G codes supported

G00	Rapid Motion
G01	Linear Interpolation Motion
G02	CW Interpolation Motion
G03	CCW Interpolation Motion
G04	Dwell
G17	XY Plane Selection
G18	XZ Plane Selection
G19	YZ Plane Selection
G20	Inch Programming Selection
G21	Metric Programming Selection
G28	Return to Machine Zero
G40	Cutter Comp Cancel
G41	Cutter Compensation Left
G42	Cutter Compensation Right
G50	RPM Max Designation
G53.1	Machine co-ordinate system
G54-G59	Work Coordinate Offset
G68.2   Coordinate rotation
G69     Coordinate rotation cancel
G70	Bolt Hole Circle
G71	Bolt Hole Arc
G72	Bolt Holes Along an Angle
G73	Hi-Speed Peck Drilling Canned Cycle
G74	Reverse Tap Canned Cycle
G76	Fine Boring Canned Cycle
G77	Back Bore Canned Cycle
G80	Canned Cycle Cancel
G81	Drill Canned Cycle
G82	Spot Drill Canned Cycle
G83	Peck Drilling Canned Cycle
G84	Tapping Canned Cycle
G85	Bore In / Bore Out Canned Cycle
G86	Bore and Stop Canned Cycle
G87	Bore In and Manual Retract Canned Cycle
G88	Bore In, Dwell, Manual Retract Canned Cycle
G89	Bore In, Dwell, Bore Out Canned Cycle
G90	Absolute Position Command
G91	Incremental Position Command
G92	Set Work Coord Sys Shift Value
G93	Inverse Time Feed
G94	Feed per Minute
G98	Return to initial point
G99	Return to reference point

------------------------------------------------------

M codes supported

M00	Program Stop
M01	Optional Stop
M03	Main Spindle on CW (Forward)
M04	Main Spindle on CCW (Reverse)
M05	Main Spindle Stop
M06	Tool Change
M08	Flood Coolant On
M09	Coolant Off
M29	Rigid Tapping
M30	End of Program
M11	Rotary axis unclamp
M10	Rotary axis clamp
M69	Tilt Axis unclamp
M68	Tilt Axis clamp
M200    Chip conveyor on
M210	Chip conveyor off

--------------------------------------------------------